Search results for "Transfer function" - Rhea

Create the page "Transfer function" on this wiki! See also the search results found.

• News
  * May, 2009: Zach finished the transfer of the remaining pages from the Old Kiwi as an exercise in learning Rhea fo * January 12, 2009: The "recent changes by category" function has been enabled. You can use it to list the changes that relate to a speci
  10 KB (1,507 words) - 03:36, 24 August 2011
• HW4.4 Tyler Houlihan ECE301Fall2008mboutin
  ...laplace transform of this function to get <math>H(s)\,</math>, the system function. My original function:
  1 KB (235 words) - 14:29, 25 September 2008
• Tyler Houlihan: Chapter 7 Notes ECE301Fall2008mboutin
  We can use a transfer function to approximate this filter, and it is: This isolates the range, and if the convolution was ideal, this function should only have a value when k=0, which would yield:
  3 KB (543 words) - 16:23, 10 November 2008
• Peer Legacy ECE202
  *Be sure to get the full story on the dirac function, convolution, bode plot approximations, and linearity. Don't rely on memori ...nsed and that made it more focussed towards laying foundation for ECE 301. Transfer functions, Laplace domain analysis, Convolution etc. are concepts used in a
  7 KB (1,297 words) - 10:41, 10 December 2011
• Student summary speech
  ...language and have different accents and because the phonemes have the same function. The end result after modeling is a transfer function that is an all-pole filter with a gain and a time delay.
  5 KB (841 words) - 14:26, 10 April 2013
• SupplementarySpeech prelecture
  - Going through tube delays the signal (show function) - between tubes (show function)
  2 KB (390 words) - 06:46, 14 November 2011
• SupplementalSpeech prelecture
  - Going through tube delays the signal (show function) - between tubes (show function)
  2 KB (387 words) - 06:47, 14 November 2011
• Snikitha ListECE202
  ...d average power, complex power, power factor correction, and maximum power transfer. Instantaneous and average power. <br/><br/> i. an ability to define and explain the meaning/function of charge, current, voltage, power, energy, R, L, C, the op amp, and the fu
  6 KB (873 words) - 16:02, 15 April 2013
• Lecture32ECE438F10
  ...length connected to a tube of zero diameter. We observed that the transfer function of such a system is an all pole filter cascaded with a time delay. The pole
  1 KB (151 words) - 11:53, 8 November 2010
• Hw5ECE438 discussion
  ...pulse response just be the convolution of a unit impulse with the transfer function ho(t) (given on pg 521 fig 7.7 of Oppenheim-Willsky)?
  1 KB (159 words) - 02:56, 29 September 2010
• Lecture20ECE438F10
  ...ystems, which led us to the concepts of "Frequency Response" and "Transfer function" of a system. We then defined a simple filter with low-pass characteristics
  867 B (122 words) - 15:21, 8 October 2010
• Lecture22ECE438F10
  ...oles/zeros with either representation (using a change of variable when the function is in terms of 1/z). We then began talking about systems defined by differe
  2 KB (393 words) - 06:25, 25 October 2010
• Hw7ECE438F10
  Obtain the frequency response and the transfer function for each of the following systems: Consider a causal LTI system with transfer function
  4 KB (661 words) - 10:22, 30 October 2011
• Lecture23ECE438F10
  ...ich the frequency response is well defined, then the poles of the transfer function should all be inside the unit circle in the complex plane.
  2 KB (329 words) - 11:04, 18 October 2010
• ECE438 Week9 Quiz
  The transfer function for this filter is given by <math> H(z) = (1-e^{j\theta}z^{-1})(1-e^{-j\the
  3 KB (480 words) - 09:42, 11 November 2011
• Lecture24ECE438F10
  ...e, we continued talking about filters and filter design using the transfer function. It seems like many students find it difficult to see the point of this stu
  1 KB (174 words) - 02:53, 21 October 2010
• Practice Question 5 ECE438F10
  * Transfer function
  2 KB (322 words) - 12:00, 26 November 2013
• ECE438 Week10 Quiz
  :a. Compute the transfer function <math>H(z)</math>, and find its poles and zeros. a. Compute the transfer function. Plot the zero-pole graph of H(z) and declare the ROC.
  3 KB (479 words) - 09:42, 11 November 2011
• ECE438 Week10 Quiz Q4sol
  ...ilter represented by this difference equation is IIR. Because the transfer function has one non-zero pole that is not cancelled out by any zero.
  2 KB (441 words) - 04:42, 28 October 2010
• ECE438 HW7 Solution
  ...between the DFT and the Fourier series coefficients of continuous periodic function x[n]? <br> The DFT of a sampled signal x[n] of length N is directly proport Function's period N = 3, <br> Using IDFT, <br> <math>\begin{align}
  19 KB (3,208 words) - 10:23, 30 October 2011
• ECE438 Week11 Quiz
  ...n for the 8-pt DFT of <math>h[n]</math>, denoted <math>H_8[k]</math>, as a function of <math>k</math>. Simplify as much as possible. Q3. Consider a causal LTI system with transfer function
  3 KB (462 words) - 09:42, 11 November 2011
• ECE438 Week11 Quiz Q1sol
  The transfer function of the first and second systems are Then, the transfer function of the combined system, <math>(T_1+T_2)[x[n]]</math> is
  1 KB (206 words) - 07:52, 4 November 2010
• ECE438 Week11 Quiz Q5sol
  Suppose the transfer function of the filter has the form Therefore, the transfer function is
  2 KB (279 words) - 16:23, 3 November 2010
• ECE600 QE 2001 January
  ..._{t}</math> be the input to a linear shift-invariant system with transfer function: Find the autocorrelation function of the input process.
  6 KB (1,093 words) - 07:23, 27 June 2012
• ECE438 Week14 Quiz
  Q1. Assume we know (or can measure) a function <br/> ...he definition of the CSFT, derive an expression for F(u,0) in terms of the function p(x).
  3 KB (515 words) - 09:43, 11 November 2011
• Lecture39ECE438F10
  ...n of the vocal tract as a sequence of tubes and the corresponding transfer function.
  629 B (88 words) - 04:05, 6 December 2010
• HW4 ECE301 Spring2011 Prof Boutin
  a) Compute the transfer function of this system. a) Compute the transfer function of this system.
  4 KB (663 words) - 14:15, 12 February 2011
• ECE301 signals systems learning material
  ...mboutin_Fourier_Coefficient_LTI_Transfer|Fourier coefficients and transfer function]] ...Non-Periodic Functions ECE301Fall2008mboutin|Animated example of periodic function]]
  6 KB (818 words) - 05:12, 16 September 2013
• HW4 ECE301 Spring2011 Prof Boutin Solutions
  b) Yes. The system could be LTI since the transfer function might be zero at this frequency and thus it will suppress it.
  12 KB (2,321 words) - 09:13, 3 March 2011
• Causal LTI System Difference Equation no1 ECE301S11
  ...lex exponential is the same complex exponential multiplied by the transfer function evaluated at the frequency of the complex exponential. The following is a b
  5 KB (793 words) - 09:28, 11 November 2011
• ECE301inBME
  **Signal processing and filtering algorithms to create stethoscopes that function in high-noise environments such as helicopters and ambulances ...oys interdisciplinary engineering approaches to examine and manipulate the function and behavior of the nervous system. &nbsp;Concepts used include computation
  17 KB (2,368 words) - 09:53, 6 May 2012
• ECE438 Lab Quizpool
  ...E438_Week11_Quiz|Describe a LTI system using Difference equation, transfer function and impulse response]] <br/>
  900 B (121 words) - 09:39, 11 November 2011
• Compute DFT practice no1 ECE438F11
  From DFT transfer pair, <math>X[k]=10\delta[k-1]</math>. repeated with period 10. This corresponds to X[k] being a delta function whose argument is [k+1].
  4 KB (735 words) - 13:19, 21 April 2013
• Lecture22ECE438F11
  ...ular, we noted how the location of the poles and the zeros of the transfer function influenced the amplitude of the frequency response.
  998 B (143 words) - 05:27, 11 September 2013
• Lecture23ECE438F11
  ...lationship between the location of the poles and the zeros of the transfer function of this filter and the amplitude of its frequency response.
  953 B (132 words) - 05:27, 11 September 2013
• Lecture24ECE438F11
  ...ditions to uniquely specify the system. We also observed that the transfer function of causal systems defined by constant coefficient difference equation is th [[Category:transfer function]]
  1 KB (142 words) - 05:27, 11 September 2013
• Hw6 ECE438F11
  ...response, and indicate the location of the poles and zeros of the transfer function. Consider a causal LTI system with transfer function
  5 KB (916 words) - 02:56, 31 August 2013
• Lecture25ECE438F11
  ...>: the values of <math>\xi</math> that correspond to poles of the transfer function (including poles at infinity) can then be transformed into the correspondin [[Category:transfer function]]
  1 KB (221 words) - 05:28, 11 September 2013
• Lecture26ECE438F11
  Having discussed how (by specify the zeros and poles of the transfer function) one can design a causal approximation of an ideal filter, we moved on to a [[Category:transfer function]]
  1 KB (164 words) - 05:30, 11 September 2013
• Hw6 ECE438F11sln
  ...g Z-transform on both sides and grouping terms, we can obtain the transfer function ...g Z-transform on both sides and grouping terms, we can obtain the transfer function
  11 KB (1,757 words) - 10:15, 30 October 2011
• Lecture30ECE438F11
  ...e of these natural frequencies are prescribes by the poles of the transfer function of the vocal tract (which are induced by the transition between tubes of di
  1 KB (182 words) - 05:31, 11 September 2013
• Digital signal processing practice problems list
  ...ga to f step function|Obtain the Fourier transform in terms of f of a step function (from FT in terms of omega)]] ...T computation rect ECE438F11|What is the Fourier transform of this DT rect function?]]
  6 KB (801 words) - 21:04, 19 April 2015
• Upsampling and downsampling lab
  ...by a fraction number. Thus the goal of this project is to design a Matlab function to mutiply the input signal frequency by a fraction to make a arbitary chan ...le by factor 3. To avoid aliasing, the filter was build by MATLAB embedded function "fir1" with order= 20, cut-of frequency =1/5.
  2 KB (389 words) - 05:37, 25 September 2013
• ECE PhD QE CNSIP Jan 2001 Problem1
  ..._{t}</math> be the input to a linear shift-invariant system with transfer function: '''(c) (5 pts)''' Find the autocorrelation function of the input process.
  4 KB (616 words) - 09:19, 13 September 2013
• ECE PhD QE CNSIP Jan 2001 Problem1.4
  ..._{t}</math> be the input to a linear shift-invariant system with transfer function:
  2 KB (234 words) - 09:37, 13 September 2013
• QE2012 AC-3 ECE580-4
  We can transfer the problem to the following standard form: ...3,</span> <span class="texhtml">''x''₂ = 6,</span> maximize the function.
  5 KB (593 words) - 09:12, 13 September 2013
• ECE301 Bonus 2 Li Pang Mo
  ...δ(t). In a LTI systems, impulse response is also equivalent to green’s function used in physics.
  2 KB (322 words) - 22:38, 10 March 2013
• ECE637 optical imaging systems space domain models S13 mhossain
  ...the lens for a given aperture by its impulse response. Its '''Point Spread Function (PSF)''' is analogous to its impulse response since the PSF describes the s The PSF will be denoted by the function <math>h(x,y)</math> in the space domain. Its CSFT will be given by <math>H(
  7 KB (1,274 words) - 06:24, 26 February 2014
• ECE270 Slecture Wayner Digital System Design Objectives Module 4
  #write the equation for the carry out function of an arbitrary CLA bit position #describe the purpose/function of each basic machine instruction (LDA, STA, ADD, SUB, AND, HLT)
  6 KB (936 words) - 06:32, 26 February 2014
• Lecture24ECE438F13
  ...values for the output; initial values for h[n]; causality; ROC of transfer function).
  2 KB (300 words) - 04:47, 16 October 2013