Difference between revisions of "HWK6MA527Fall2013" - Rhea

Revision as of 07:41, 9 October 2013

Homework 6 collaboration area

Question from A. Piggott

Section 6.1, problem 1 and 2, I solved with Integration by Parts.

Is this the least time consuming way to solve them? What is the best way?

Also, 6.1, #5, when I solve with integration by parts, I get a solution that always requires another integration by Parts so I am not getting anywhere. Can anyone help on this?

Response from Mickey Rhoades Mrhoade

I used integration by parts for 1,2, and 5.  They weren't too terrible.  Obviously, these transforms are covered in the table but going through the motions to transform them was the point.  You can check your answers using the table.  For #5, I broke sinh(t) into its exponential components and then you get two seperate integrals. you should have one transform of e^3t and then a transform of e^t.  You should get F(s) = .5/(s-3) - .5/(s-1). You get common denominators and this becomes:

1/(s-3)(s-1)  = 1/(S^2-4S+3)  you then add 1 and subtract 1 on the denominator to complete the square.  

Response from Alfred Piggott APiggott

Thanks Mickey!

I am sort of stuck on Lesson 19 #26:

First of all, are the instructions correct when they say "...if L(F) equals:" --- Is it F or f(t)?

Secondly, I am not sure how to proceed with this. Thm 3 says the inverse Laplace is 1/s times the F(s) function. Therefore I can factor out a 1/s^3 to get : (1/s^3)*(1/(s^2-1)) ...Not sure where to go from here, or if my approach is wrong...

Thanks - Mac

I think you need to factor out s^2 to get (1/(s^2)*(s^2-1)), also question says inverse transform by integral which is done in example 3. If you will integrate inverse transform of (1/(s^2-1)) i.e., sinh t twice you will get inverse transform of (1/(s^4-s^2)) i.e., sinh t - t. (I am not sure, if I am right)

-- Kunal

Response from Mickey Rhoades (mrhoade~~)

I did the same thing and got the same answer. After the first integration of sinh(t) you get cosh(t) -1 and integrate that to find the solution of sinh(t )- t.

Question from T. Roe 21:28, 6 October 2013 (UTC):

I have a question on Lesson 19 #19. I have set up the equations as follows:

$ \mathcal{L}(f')=s\mathcal{L}(f)-f(0) $

f(0) = 0

so

$ \mathcal{L}(f)=\mathcal{L}(f')/s. $

Using the information from class I get:

$ \mathcal{L}(f')=\frac{2\omega}{(s^2+4\omega^2)} $

and

$ \mathcal{L}(f)=\frac{2\omega}{s(s^2+4\omega^2)}, $

but the book as well as mathematica output a solution of

$ \mathcal{L}(f)=\frac{2\omega^2}{s(s^2+4\omega^2)}. $

Can someone explain to me where the extra ω is coming from?

Response from Mickey Rhoades Mrhoade

I started by changing sin²(wt)  into 1/2-cos(2wt)/2  I took f'(t) to be wsin(2wt) with f'=0.  f''(t) = 2w² * cos(2wt)

Then, I took L[f(t)] to get s²F=2w2(-2F + L[1]).  The trick was to recognize that if f(t) = 1/2-cos(2wt)/2 you can rearrange and find cos(2wt) = -2*f(t) + 1.  Then when you set the right side of the equation of the Laplace transform of the second derivative to be 2w² * cos(2wt) you can substitute and make the right side 2w²(-2*f(t) + 1) which transforms to 2w²(-2F + 1/s). Set is equal to your earlier obtained s²F

(s² + 4w²)F = 2w²/s

Response from Seth Beckley beckleys

I believe you can also solve this problem without the conversion to 1/2-cos(2wt)/2.  Using the Chain Rule, find f'(t) to be 2w*sinwt*coswt.  (I think the w on the left side of the derivative was left out when we derived it in class, which would explain the missing w, T. Roe.) We then can find the Laplace transform of f'(t) to be:

$ \mathcal{L}(f')=\frac{2\omega^2}{(s^2+4\omega^2)} $

Recognizing that the Laplace transform of f'(t) is also equal to s*F(s) - f(0), and that f(0) = sin^2(0) = 0, we can set both forms of the Laplace transform of f'(t) equal to each other to get:

$ s\mathcal{}F(s)=\frac{2\omega^2}{(s^2+4\omega^2)} $ 

We can then solve for F(s) to find:

$ F(s)=\frac{2\omega^2}{s(s^2+4\omega^2)} $

Question 13 on pg. 223: I think the answer of the book is not correct >> 2[1+u(t-�pi)]sin3t. Instead of "+" between 1 and u(t-pi) it should be "-". Am I right? Thanks!

response from Mickey Rhoades Mrhoade

I made the same mistake the fist time through, but I checked the answer in Maple so I reworked it and found my mistake.  When you use the triginometric difference formula, you will have one term vanish from sin (3pi) and the other has a cos(3*pi).  This is a (-1) and it multiplies times the -2 * u(t-pi) to make it positive.  --Mick

Question from Tlouvar

On Lesson 19 #26, building on above:  I understand factoring out the s^2, but I'm confused why you need to integrate twice.  Maybe someone can explain that part a little better.  Thanks, Tim.

Response from Mickey Rhoades Mrhoade

Tlouvar,

You need to "differentiate" twice.  The method to solving these problems is to get a funtion on the right that looks like the original function so you can substitute in an f(t), but it is derivative of some order.  With exponentials, this can usually be accomplished with one differentiation, however, with triginometric functions, it takes two differentiations to produce a function that looks like the original.  You need to get a function on the right you can sub in f(t) for so that when you perform the Laplace transform you get F.   The trick, or the big fact (as Dr. Bell likes to say) is that you can do away with all the t's and come up with right and left sde of all s's.  Once you are dealing with all s's it becomes an algebra problem.  I hope this explanation is sufficient...  -Mick

     Question 25 on pg 223: The system is equal to t for 0<t<1, this is  t*[1-u(t-1)] so it is a ramp, and it is zero everywhere else. So, if it is 0 for t>1 do we need to compute something else here? The back of the book gives you an answer for t > 1, but I don't understand why.  - G.Noriega

response from Mickey Rhoades Mrhoade

It is not a ramp because there is a second derivative in there.  the answer in the back is what I get, and from 0 to 1 the function is t-sin(t).  Then for t > 1 you add in [cos(t-1} + sin(t-1) -t)

From Mnestero:

On Prob 10 of 6.3, on the switch u(t-2)sinh((t-2)+2), I took the +2, knowing that sinh = (e^t - e^-t)/2, and just factored out an e^2 so that e^2*u(t-2)sinh(t-2). Is this correct, or am I way off?

Response from Mickey Rhoades Mrhoade

You should start with u(t)*sinh(t) - u(t-2)*sinh(t).  The first part is easy to transform, however to use s-shifting you are correct to add and subtract two.  Your way won't work though because you will have e^(t-2+2) - e^-(t-2+2) / 2 and then what you have is an e² in the left term and an e^-2 in the right term because you need the e^-t+2 term to keep your sinh(t-2).

Also, it will be much more difficult to solve this problem with exponentials because you get an e^-t and you will have a hard time getting the t-2 you need in the exponential.

When you transform the sinh(t) you get 1/s²-1. Use the difference identity to turn sinh((t-2)+2) into sinh and cosh expressions.  You will then transform u(t-2)*cosh(t-2)*sinh(2) and u(t-2)sinh(t-2)cosh(2).   sinh(2) and cosh(2) are constants and you should end up with something like F(s) = (1 - e-^2s( s*sinh(2) + cosh(2)))/(s²-1)

From Mnestero:

Ok, that makes more sense. I did not realize that the hyperbolic sine and cosine functions had similar difference identities to the regular sine and cosine functions. For anyone who is also hairy on the sinh and cosh difference identities see: http://math.uchicago.edu/~vipul/teaching-0910/153/hyperbolicfunctions.pdf

From Steve Bell:

Find some hints about p. 223: 39. at the very bottom of

[Aftermath of Lesson21]

from Jayling: any clues for Page 210 Question 23 (I hate the theoretical questions!)

Hint from Steve Bell:

Write out the definition of L[f(ct)] and then perform a change of variables, letting tau=ct. The result will just pop out after that.

Back to MA527, Fall 2013