Line 108: Line 108:
  
 
<math>\text{If } x_d[n]=x(nT), \text{ then } X_d(\omega) = \frac{1}{T} \sum_{k=-\infty}^\infty X \left(  \frac{\omega}{2\pi T}+\frac{k}{T}\right).</math>
 
<math>\text{If } x_d[n]=x(nT), \text{ then } X_d(\omega) = \frac{1}{T} \sum_{k=-\infty}^\infty X \left(  \frac{\omega}{2\pi T}+\frac{k}{T}\right).</math>
 +
 +
Now to check that this expression is correct, it is a good idea to check that <math class="inline">X(\omega)</math> is periodic with period <math class="inline">2\pi</math>
  
  

Revision as of 15:02, 14 December 2010

Practice Question 4, ECE438 Fall 2010, Prof. Boutin

Frequency domain view of filtering.

Note: There is a very high chance of a question like this on the final.


Define a signal x(t) and take samples every T (using a specific value of T). Store the samples in a discrete-time signal z[n]. Obtain a mathematical expression for the Fourier transform of x(t) and sketch it. Obtain a mathematical expression for the Fourier transform of y[n] and sketch it.

Let's hope we get a lot of different signals from different students!

  • Instructor's note: if you make a mistake and somebody else comments on it, please do not remove it when you make corrections later. Instead, just start over below your previous answer. The idea is to learn from our mistakes! -pm

Post Your answer/questions below.

I thought I would start with a function that had a simple F.T.

$ x(t) = \delta(t), T=1 $

$ \begin{align} z[n] &= x_T[n] \\ &= \delta(t+T) \end{align} $

Fourier Transform of x(t) = 1

$ y[n] = x(t)*z[n] $ <-- is this correct?

  • No, there is a serious problem with your signal y[n]: it's defined as a function of both t and n. It should NOT depend on n.

I only solved the general form for this problem.

$ \begin{align} \mathcal{F}(x(t)) = \int_{-\infty}^{\infty} x(t)e^{-j\omega t} \end{align} $

$ \begin{align} z[n] = comb_T(x(t)) \end{align} $

  • Oops! Your z[n] is actually a function of t (because a comb is the multiplication of two functions of t, namely the signal x(t) and an impulse train p(t) .

I'm not sure what y[n] is equal to. I'm assuming that y[n] is the same as z[n]. Then the FT of y[n] is

$ \begin{align} Y(e^{j\omega}) = \frac{1}{T}rep_\frac{1}{T}(X(e^{j\omega})) \end{align} $


- Mike Wolfer


T=3

$ \begin{align} x(t)=cos(2t) \end{align} $

Sampling consists mathematically of a substitution of t->3n Therefore,

$ \begin{align} z {\color{red} [}(n){\color{red} ]} = cos(2(3n)) \end{align} $


To make calculations easier Euler Form is used:

$ \begin{align} cos(6n) -> {\color{red} =} 1/2(e^{i6n}+e^{-i6n}) \end{align} $

Inverse CTFT: (You should use the formula in terms of f in hertz.)

$ x(t) = \frac{1}{2\pi} \int_{-\infty}^{\infty} \! X(\omega)e^{j \omega t} dw $

$ 1/2e^{i2t}+1/2e^{-i2t} = \frac{1}{2\pi} \int_{-\infty}^{\infty} \! X(\omega)e^{j \omega t} dw $

Table -> (Here you could just say "The function X(f) that satisfies this equation is")

$ \begin{align} x(f)=1/2(\delta(f - 2/(2\pi)) +\delta(f + 2/(2\pi))) \end{align} $

Sketch consists of two positive spikes, at 1/pi and -1/pi on the X axis(f).

IDFT:

$ x[n] = \frac{1}{2\pi} \int_{-\infty {\color{red}-\pi} }^{\infty {\color{red} \pi} } X(\omega)e^{j \omega n} d\omega $

$ 1/2e^{i6n}+1/2e^{-i6n}= \frac{1}{2\pi} \int_{-\infty {\color{red}-\pi}}^{\infty {\color{red} \pi}} X(\omega)e^{j \omega n} d\omega $

Table -> (You could just say "The function z(w) that satisfies this equation is the following, where k is an integer chosen so that the spikes lie between -pi and pi.")

$ \begin{align} z(w)=\pi( \delta(\omega -6{\color{red}+2\pi k}) +\delta(\omega+6{\color{red}+2\pi k}) ){\color{red}, -\pi<w<\pi } \end{align} $

Sketch consists of a pair of spikes repeated every 2 pi. Given that the original is not in the initial +/-pi range, it is shifted by 2 pi intervals till the spikes are within.

6-2pi-> spikes at +/- .283

Instructor's note: The method used above directly relies on the FT formulas. This is a good way to attack such problems if you don't remember the relationship between the sampling and the signal (although I do hope you will remember it for the test). -pm

Can you please be elaborated on how to handle sampling mathematically? The only representation we have is in a graphical manner, and that makes it really difficult to demonstrate the relationship between sampling and the signal in a concrete, non-picture form. ~Ajfunche

Instructor's answer. Sure. Let me first give you a single mathematical expression to describe this relationship:

$ \text{If } x_d[n]=x(nT), \text{ then } X_d(\omega) = \frac{1}{T} \sum_{k=-\infty}^\infty X \left( \frac{\omega}{2\pi T}+\frac{k}{T}\right). $

Now to check that this expression is correct, it is a good idea to check that $ X(\omega) $ is periodic with period $ 2\pi $



  • Answer/question

Previous practice problem

Next practice problem

Back to 2010 Fall ECE 438 Boutin

Alumni Liaison

Ph.D. 2007, working on developing cool imaging technologies for digital cameras, camera phones, and video surveillance cameras.

Buyue Zhang